EEVblog Electronics Community Forum

Electronics => Projects, Designs, and Technical Stuff => Topic started by: μSoldering on February 19, 2024, 12:59:07 am

Title: Reverse-Engineering a Switch Lite Boardview at 6,000 Pixels Per Inch
Post by: μSoldering on February 19, 2024, 12:59:07 am

Electrical engineers and other friends, I recently completed a project to turn finished PCBA's into boardviews with accompanying boardscans you can read about here: https://usoldering.com/switch-lite/ (https://usoldering.com/switch-lite/). Aside from being a less stressful side-job, I'd like the project to serve as a foundation for other reverse/electrical engineers to build additional interesting content off of. Basically, in the off-chance someone did want to start decapping dies or build a schematic, I'd to (within reason) make their lives easier. I plan on including LCR data from the chip components, and I did get some feedback about impedance measurements for LCD data lines, but is there any other suggestions or feedback from the electrical engineering perspective that I can incorporate? Thanks.

[attach=1]