Electronics > Projects, Designs, and Technical Stuff

Review on YiHua 878D

(1/1)

madhu.wesly01:
Hi,

I am planning to buy YiHua 878D 2 in 1 soldering rework station. Previously, I have used Hakko's FX-888D soldeing station and YiHua 858D rework station. This time I want to take an integrated one(multi-function) like 878D. Please let me get your review/comments on this product. Will it perform at-least parallel(or comparable) to the FX-888D & 858D?

TIA.

Regards,

OM222O:
I bought the 862D+ off of amazon. it's been pretty decent so far, but the supplied conical tip with the iron is garbage and dies quickly. I also had the magnetic switch in the hot air gun break but after replacing it with a high quality one everything has been buttery smooth. the main advantage is it's so cheap, you can't beat it in terms of value.

madhu.wesly01:
Any suggestions/comments on YiHua 878D..?

Regards,

OM222O:
all yihua products are basically the same, with some marginal differences in the feature set which you can find on their website. what I said about the 862D+ holds true for the 878D as well. just check the feature set before you buy (862D+ is a better version and not that much more expensive than the 878D).

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod