Electronics > Projects, Designs, and Technical Stuff
RF design and layout [questions/feedback]
(1/4) > >>
aaronhance:
Hello! I'm designing a board with an LNA and filter and am looking for some feedback. I also have a question about ground filling the top layer; what distance should I observe from rf traces to ensure the same 50ohm impedance? Also, would a metal can help improve the performance of the board in a significant way?

Layout:
http://prntscr.com/o6c1q5
http://prntscr.com/o6c1wr
impedance calculations:
http://prntscr.com/o6c251
Thanks again!
Ysjoelfir:
403 Forbidden.
Yansi:
Upload the images to the forum directly!  :scared:
aaronhance:
Uploaded images,  |O
Yansi:
That does not look right at all.

What are you trying to achieve? What is your goal?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod