Electronics > Projects, Designs, and Technical Stuff

Safe way to apply voltage on output of buck converter?

(1/1)

llkiwi2006:
I am doing a design with supercaps for power backup and I'm using a LMR14030 buck converter to charge the caps. I am worried that the ic is not designed to have power applied to the sw pin. I added a diode (D5) to vin to prevent current leaking back into the input rail, and I am using the en pin to disable the ic until vin is higher than the maximum voltage on the supercaps. Will this work fine?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod