Electronics > Projects, Designs, and Technical Stuff
SIMETRIX sweeping through multiple parameters simultaneously.
(1/1)
Glenn0010:
Hi All,

I would like to sweep both through the current and gate resistor in my circuit simultaneously. Ideally I could also set the temp to 125 for example.

I have managed to get it to sweep through one at a time but not more than one simultaneously. I can't seem to find documentation online to do this.

Can anyone help?

this is what I am doing to sweep through one parameter.


--- Code: ---.simulator SIMETRIX
.TRAN 20u SWEEP SINGLE PARAM=Current LIST  100m 200m 500m 1 2 3 5 10 15 20 25 30
.simulator DEFAULT

--- End code ---

I have tried different syntax to try to get it to run but can't figure it out.

 
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod