Electronics > Projects, Designs, and Technical Stuff

SIMETRIX sweeping through multiple parameters simultaneously.

(1/1)

Glenn0010:
Hi All,

I would like to sweep both through the current and gate resistor in my circuit simultaneously. Ideally I could also set the temp to 125 for example.

I have managed to get it to sweep through one at a time but not more than one simultaneously. I can't seem to find documentation online to do this.

Can anyone help?

this is what I am doing to sweep through one parameter.


--- Code: ---.simulator SIMETRIX
.TRAN 20u SWEEP SINGLE PARAM=Current LIST  100m 200m 500m 1 2 3 5 10 15 20 25 30
.simulator DEFAULT

--- End code ---

I have tried different syntax to try to get it to run but can't figure it out.

 

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod