| Electronics > Projects, Designs, and Technical Stuff |
| Simple DC AFE for ADC chips with unipolar diff inputs |
| << < (4/4) |
| David Hess:
--- Quote from: imo on January 23, 2019, 08:43:04 pm ---Do you mean to use fets in the bootstrap? The divider there - what to use? - a capacitive divider ? :) --- End quote --- Buffer the output of the precision operational amplifier to drive the bootstrap circuit which currently as shown has a parallel load resistance of about 10k which is not particularly low but every bit helps. |
| iMo:
This is with buffering the bootstrap, and 18k/2k divider. The larger the source impedance feeding the ADC, the worse.. |
| David Hess:
Many implementations work in exactly that way with an operational voltage follower to drive just the bootstrap circuit. |
| iMo:
And these are the simulation results with above v7. Note: 1. source resistance of the input Voltage source is 1Meg 2. optimal resistor's tempcos with the two dividers 3. LM741 model used for the rail splitter and the bootstrap buffer. |
| iMo:
v32 with low leakage input protection.. |
| Navigation |
| Message Index |
| Previous page |