Electronics > Projects, Designs, and Technical Stuff
Simple way to show ethernet packet timing on scope
<< < (7/7)
t1d:

--- Quote from: cdev on November 09, 2018, 09:47:00 pm ---I am almost 100% certain that one can't use a cheap logic analyzer to decode Ethernet.
--- End quote ---
Thanks for that clarification edit, because I wasn't quiet sure what I was in error about. Yeah, I didn't know, if it would be helpful, but I was trying to be helpful;-)


--- Quote from: cdev on November 09, 2018, 09:47:00 pm --- That doesn't make it morally right to use their software without having bought their hardware.
--- End quote ---
Agreed. And, if I had not seen an article about Saelea's position, I would not have downloaded their program. I'm sorry, but I did not bookmark the reference. I did watch the PulseView author's YouTube video and, IIRC, it is open source and he has turned over its continued development to the community. But, it has been a good long while, since I looked at this stuff.

Thanks, for the info. It was interesting.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod