Electronics > Projects, Designs, and Technical Stuff
SMD at home
<< < (6/6)
mayor:

--- Quote from: JVR on April 17, 2019, 12:13:07 pm ---Also, pony up for ENIG, HASL can sometimes be so uneven that it lifts the stencil locally, causing massive smudges.

--- End quote ---

Ouch! If I do any sort of volume, I will consider it. But right now, at JLCPCB, the extra cost of the surface finish is 8x that of the boards themselves :-)

@coromonadalix
Did you figure out what the green pot brand is?
daveyk:
Neat video!  Me, I would have just soldered that chip via conventional means with my small conical tip Hakko. lol
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod