Electronics > Projects, Designs, and Technical Stuff

SMD at home

<< < (6/6)

mayor:

--- Quote from: JVR on April 17, 2019, 12:13:07 pm ---Also, pony up for ENIG, HASL can sometimes be so uneven that it lifts the stencil locally, causing massive smudges.

--- End quote ---

Ouch! If I do any sort of volume, I will consider it. But right now, at JLCPCB, the extra cost of the surface finish is 8x that of the boards themselves :-)

@coromonadalix
Did you figure out what the green pot brand is?

daveyk:
Neat video!  Me, I would have just soldered that chip via conventional means with my small conical tip Hakko. lol

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod