Electronics > Projects, Designs, and Technical Stuff

SMD prototyping techniques -- looking for advice

<< < (6/8) > >>

HB9EVI:
as being notoriously too lazy laying out and etching pcbs, I use dremel drilled islands for Rs, Cs, and transistors, dead bug for DIP chips and TSSOP/LQFP adapter boards in every needed combination; however I'm avoiding BGAs so far since the wiring is somehow suspicious to me, but maybe I change my opinion if there'll be no alternative to such a chip.

I do everything in that manner - from DC to lower GHz range

Siwastaja:
The smallest TH resistors (with thinnest leads possible) are great for SMD bodges, because they double as a resistor and wire. Much quicker to solder than an SMD resistor, then a wire to it.

But often you don't have small enough TH parts available.

poorchava:
In the company where i work we often have weird-shaped boards, so we can add protoboards on the waste areas of the panel. We literally have like 100kg of protoboards at hand :).

Privately, I use something similar to what Mike Harrison (mikeselectricstuff) is selling: http://www.whitewing.co.uk/protoboard.html

mark03:

--- Quote from: techman-001 on July 28, 2019, 02:06:42 am ---This is a deadbug technique I'm experimenting with. I have more pictures and details on my doc page at:
 https://mecrisp-stellaris-folkdoc.sourceforge.io/prototyping.html#prototyping

--- End quote ---

Tempted to draw an analogy between this and programming in Forth, but I won't  >:D

Seriously, that is impressive.  You have way more patience than I.

On the main topic, I may be lucky, but I almost always prototype with a custom PCB and some common-sense measures like extra pads, etc.  I can only think of one "coaster" I've made out of a couple dozen boards.  It's the rare case that can't be reworked with some bodge wires and creativity.

ogden:

--- Quote from: mark03 on July 29, 2019, 06:25:36 pm ---Tempted to draw an analogy between this and programming in Forth, but I won't  >:D

--- End quote ---

LOL :) Building miniature ships in a bottle is another analogy that comes into mind. Someone who is doing deadbug for >200pin circuit that includes 0.5mm pitch chips, clearly do not value his time.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod