Electronics > Projects, Designs, and Technical Stuff

SPWM hardware

(1/2) > >>

Achu:
Hi,

Could any one guide me on how to create a hardware to make spwm alternating on two two outputs for each half cycle.
I indent not to use a micro-controller.(Though using an u-Controller is easy)

Psi:
You need to explain more about what you are after.
What signals are the inputs and what are the outputs?

If not using a micro controller then you are going to need compactors and latches/flipflops

Achu:
My aim is to create alternating spwm signals corresponding to each half cycle by comparing sine and ramp/triangular wave.I believe it is evident from the picture.
Yes I'm willing to do it the hard way by not using programming.
I might use it to drive an H bridge to make a crude inverter.

pwlps:

--- Quote from: Achu on May 30, 2019, 03:37:01 am ---My aim is to create alternating spwm signals corresponding to each half cycle by comparing sine and ramp/triangular wave.I believe it is evident from the picture.
Yes I'm willing to do it the hard way by not using programming.
I might use it to drive an H bridge to make a crude inverter.

--- End quote ---

It is not evident from the picture because there is an inconsistency: comparing sine and ramp/triangular wave from the top picture would yield a 50% duty cycle near zero voltage (single pulse PWM) but this is not the case for the bottom picture signal where you would you need a multiple-pulse pwm.  Figure 5.4 in the following link shows how to modify your triangular reference.
https://shodhganga.inflibnet.ac.in/bitstream/10603/33606/10/10_chapter5.pdf

Achu:
My sincere apologies.I am a noobie.
But do you understand what I am trying to communicate?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod