| Electronics > Projects, Designs, and Technical Stuff |
| Square holes on aluminum.... how do you do it? |
| << < (20/20) |
| tautech:
--- Quote from: beanflying on March 04, 2020, 01:03:20 am --- --- Quote from: tautech on March 04, 2020, 12:55:58 am --- --- Quote from: beanflying on March 04, 2020, 12:49:40 am ---On Rake angle I have been looking at getting a zero rake Saw blade for my tracksaw for Acrylic and Aluminium for a T Slot build I have coming up but I am making do with the thin kerf Plywood blade for breaking down Acrylic sheets for my Laser and doesn't chip. --- End quote --- Crosscut blades have entirely different rake to ripping or combo blades....go down that rabbit hole. ;) --- End quote --- I have both already the saw came with a Rip/Combo blade and I added one of these https://www.bunnings.com.au/diablo-165mm-6-5-40-teeth-fine-finish-cordless-circular-saw-blade_p6370899 for Ply and Panel working great so far only runs a shallow rake. --- End quote --- Yes because the depth of cut and therefore control is done with a depth gauge instead of a tooth rake best suited to the material or the job. Horses for courses. :horse: |
| Navigation |
| Message Index |
| Previous page |