Electronics > Projects, Designs, and Technical Stuff
Stepper motor specs and drivers
<< < (3/3)
beanflying:
Your Rotary won't pull much current unless you are trying to rotate heavy lumps with Vector moves so I would use it if you have it. There is a 24V curve here for it http://www.stepmotor.cn/download/1.8dj/57BYG.pdf If you keep to just engraving/scan lines I can't see it being a problem unless you stall/jam the drive.

The simple option for a test is just plug it into your current Y driver and calibrate the rotary. Set your acceleration and speed fairly low if you are worried
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod