Electronics > Projects, Designs, and Technical Stuff
Stepper motor specs and drivers
beanflying:
Your Rotary won't pull much current unless you are trying to rotate heavy lumps with Vector moves so I would use it if you have it. There is a 24V curve here for it http://www.stepmotor.cn/download/1.8dj/57BYG.pdf If you keep to just engraving/scan lines I can't see it being a problem unless you stall/jam the drive.
The simple option for a test is just plug it into your current Y driver and calibrate the rotary. Set your acceleration and speed fairly low if you are worried
Navigation
[0] Message Index
[*] Previous page
Go to full version