Electronics > Projects, Designs, and Technical Stuff
Sterilizing masks with a Crock Pot slow cooker
<< < (3/3)
profdc9:
The only mains lines are the thick lines.  How much further could I space them from the coil side?  The trace is 1.5 mm in width, and there's about 3 mm width.    3 mm is good for at least 500 volts. 

https://www.smps.us/pcbtracespacing.html

Anyways, I could see it could be improved, so I improved it.  Thank you.
wraper:

--- Quote from: profdc9 on April 13, 2020, 09:18:59 pm ---The only mains lines are the thick lines.  How much further could I space them from the coil side?  The trace is 1.5 mm in width, and there's about 3 mm width.    3 mm is good for at least 500 volts. 

https://www.smps.us/pcbtracespacing.html

Anyways, I could see it could be improved, so I improved it.  Thank you.

--- End quote ---
This PCB is not earthed, so you should use reinforced creepage. BTW you did not fix it completely.

profdc9:
Ok, I moved the relay away and moved the track.  Should be ok now?

wraper:
Should be fine in terms of safety. BTW some pads you use are too small.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod