Electronics > Projects, Designs, and Technical Stuff

Sterilizing masks with a Crock Pot slow cooker

<< < (3/3)

profdc9:
The only mains lines are the thick lines.  How much further could I space them from the coil side?  The trace is 1.5 mm in width, and there's about 3 mm width.    3 mm is good for at least 500 volts. 

https://www.smps.us/pcbtracespacing.html

Anyways, I could see it could be improved, so I improved it.  Thank you.

wraper:

--- Quote from: profdc9 on April 13, 2020, 09:18:59 pm ---The only mains lines are the thick lines.  How much further could I space them from the coil side?  The trace is 1.5 mm in width, and there's about 3 mm width.    3 mm is good for at least 500 volts. 

https://www.smps.us/pcbtracespacing.html

Anyways, I could see it could be improved, so I improved it.  Thank you.

--- End quote ---
This PCB is not earthed, so you should use reinforced creepage. BTW you did not fix it completely.

profdc9:
Ok, I moved the relay away and moved the track.  Should be ok now?

wraper:
Should be fine in terms of safety. BTW some pads you use are too small.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod