Electronics > Projects, Designs, and Technical Stuff
STP1612PW05 LED driver
(1/1)
alizare368:
Hi
 I used these codes to run the RGB LED DRIVER(stp1612pw05), but it does not work.
the PWCLK is 2M.

--- Code: ---
 #define SPI_SCLK_LOW_TIME  200
 #define SPI_SCLK_HIGH_TIME 1

uint16_t SPI_1(uint16_t byte_out)
{
  uint16_t byte_in =0;
  uint16_t bit;


for(i=0;i<16;i++)
{
        //LE pin is low
HAL_GPIO_WritePin(GPIOB,GPIO_PIN_9,GPIO_PIN_RESET);

for (bit = 0x8000; bit; bit >>= 1)
{

/* Shift-out a bit to the MOSI line */
HAL_GPIO_WritePin(GPIOB,GPIO_PIN_4,(byte_out & bit) ? GPIO_PIN_SET : GPIO_PIN_RESET);


/* Delay for at least the peer's setup time */
for(int i=0;i<SPI_SCLK_LOW_TIME;i++)
{
}

/* Pull the clock line high */
HAL_GPIO_WritePin(GPIOB,GPIO_PIN_5,GPIO_PIN_SET);


// /* Shift-in a bit from the MISO line */
// if(HAL_GPIO_ReadPin(GPIOC,GPIO_PIN_8)==1)
// byte_in |= bit;
//

/* Delay for at least the peer's hold time */
for(int i=0;i<SPI_SCLK_HIGH_TIME;i++)
{
}


/* Pull the clock line low */
HAL_GPIO_WritePin(GPIOB,GPIO_PIN_5,GPIO_PIN_RESET);




}

        //LE pin is high
HAL_GPIO_WritePin(GPIOB,GPIO_PIN_9,GPIO_PIN_SET);
HAL_Delay(1);

}



//return byte_in;

}

while (1)
{
    SPI_1(0xffff);
}

--- End code ---
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod