Electronics > Projects, Designs, and Technical Stuff

Strain Gauge Amplification Circuit

<< < (3/3)

djsb:
http://en.wikipedia.org/wiki/Young%27s_modulus

and mechanical properties in

http://en.wikipedia.org/wiki/List_of_materials_properties

David.

TechGuy:

--- Quote from: v1nd on August 29, 2010, 02:22:16 am ---So I'm working with some 350? strain gauge's, and I'm looking to buy some industrial, pre-made amplification circuits. I have a couple of one's I designed for 120? and I understand that it's really quite easy to make the switch, but I'd rather try to see if I can get an industrial one (that I can trust more than my own) for less than $200-$300 before I risk making my own. I don't have any indication of where the gauge was bought or anything, just measured the ends with an ohmmeter, so there's not really anymore information to be had. Any suggestions?

Thanks,

--- End quote ---

Try Omega Engineering http://www.omega.com/
McMaster might also sell them too http://www.mcmaster.com

qno:
I have just been working with one of these. They are OK.

Look here:

http://www.magtrol.com/datasheets/lmu209.pdf

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version