| Electronics > Projects, Designs, and Technical Stuff |
| Suitable board to board connectors - Gigabit ethernet + misc GPIO and Power |
| (1/1) |
| mrpackethead:
I'm lookign for a connect that is suitable for connecting the differnetial pairs of gigabit ethernet (Phy side) across. I need to do at least pairs. The use case is a processor daughter board that sits on a mother board. The PCB requirements for the processor board vs the motherboard make it very difficult to built it as a single pcb. |
| Scrts:
--- Quote from: mrpackethead on January 21, 2019, 07:17:03 pm ---I'm lookign for a connect that is suitable for connecting the differnetial pairs of gigabit ethernet (Phy side) across. I need to do at least pairs. The use case is a processor daughter board that sits on a mother board. The PCB requirements for the processor board vs the motherboard make it very difficult to built it as a single pcb. --- End quote --- Before going ahead with the recommendations, you probably understand that it's a very bad idea in terms of EMC? The gigabit lines are strong and emit left and right... |
| Navigation |
| Message Index |