Author Topic: Suitable board to board connectors - Gigabit ethernet + misc GPIO and Power  (Read 737 times)

0 Members and 1 Guest are viewing this topic.

Offline mrpacketheadTopic starter

  • Super Contributor
  • ***
  • Posts: 2845
  • Country: nz
  • D Size Cell
I'm lookign for a connect that is suitable for connecting the differnetial pairs of gigabit ethernet (Phy side) across.   I need to do at least pairs.  The use case is a processor daughter board that sits on a mother board.   The PCB requirements for the processor board vs the motherboard make it very difficult to built it as a single pcb.

On a quest to find increasingly complicated ways to blink things
 

Offline Scrts

  • Frequent Contributor
  • **
  • Posts: 800
  • Country: lt
I'm lookign for a connect that is suitable for connecting the differnetial pairs of gigabit ethernet (Phy side) across.   I need to do at least pairs.  The use case is a processor daughter board that sits on a mother board.   The PCB requirements for the processor board vs the motherboard make it very difficult to built it as a single pcb.

Before going ahead with the recommendations, you probably understand that it's a very bad idea in terms of EMC? The gigabit lines are strong and emit left and right...
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf