Electronics > Projects, Designs, and Technical Stuff

Suitable board to board connectors - Gigabit ethernet + misc GPIO and Power

(1/1)

mrpackethead:
I'm lookign for a connect that is suitable for connecting the differnetial pairs of gigabit ethernet (Phy side) across.   I need to do at least pairs.  The use case is a processor daughter board that sits on a mother board.   The PCB requirements for the processor board vs the motherboard make it very difficult to built it as a single pcb.

Scrts:

--- Quote from: mrpackethead on January 21, 2019, 07:17:03 pm ---I'm lookign for a connect that is suitable for connecting the differnetial pairs of gigabit ethernet (Phy side) across.   I need to do at least pairs.  The use case is a processor daughter board that sits on a mother board.   The PCB requirements for the processor board vs the motherboard make it very difficult to built it as a single pcb.

--- End quote ---

Before going ahead with the recommendations, you probably understand that it's a very bad idea in terms of EMC? The gigabit lines are strong and emit left and right...

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod