Electronics > Projects, Designs, and Technical Stuff

Summing a stereo signal

<< < (3/3)

dmills:
6dB? I don't see the issue, but to the extent there is one, the answer is to pad the stereo units down by 6dB to match the mono ones not the other way around.

I would suggest a pair of 100 ohm resistors would make a suitable pad for each channel of each stereo synth, 200R (series) is largeish compared to most headphones, but 50 ohms (parallel) is small compared to the 10k of the mixers line input.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod