Electronics > Projects, Designs, and Technical Stuff
Termination of shield on ribbon cable
<< < (3/5) > >>
wraper:

--- Quote from: coppercone2 on November 18, 2018, 03:50:07 pm ---For anything but production with pneumatic calibrated tools I would recommend solder cup types for DB cables.

--- End quote ---
Actually with usual IDC it's very hard to do anything wrong unlike with crimp connectors. There is a fixed distance how much you can push the clip until connector fully closes and you cannot push any further. I usually simply place IDC connectors in a vice (with flat shims).
wraper:

--- Quote from: ahbushnell on November 18, 2018, 10:55:32 am ---I'm not familiar with fast-on connector?  Where do I find that? 

--- End quote ---
google.



coppercone2:
https://www.te.com/commerce/DocumentDelivery/DDEController?Action=showdoc&DocId=Catalog+Section%7F82004_FASTIN_FASTON_Product_Line%7F0311%7Fpdf%7FEnglish%7FENG_CS_82004_FASTIN_FASTON_Product_Line_0311.pdf%7F180907
coppercone2:
but for a ground you need to use the ring terminal that's tensioned by a screw
wraper:

--- Quote from: coppercone2 on November 18, 2018, 04:35:37 pm ---but for a ground you need to use the ring terminal that's tensioned by a screw

--- End quote ---
Why you would do something like this? It's a shield, not Mains earth connection.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod