Electronics > Projects, Designs, and Technical Stuff
Termination of shield on ribbon cable
<< < (5/5)
ahbushnell:

--- Quote from: SeanB on November 18, 2018, 11:56:02 am ---Fast-on connector, that spade terminal found on small lead acid batteries, on your car and pretty much every electric part used in airconditioners. A way to make assembly faster, but still capable of low resistance, decent resistance to corrosion and does not come loose easily.

--- End quote ---
How does a fast-on connect to braid on a shield?
wraper:

--- Quote from: ahbushnell on November 18, 2018, 06:36:29 pm ---
--- Quote from: SeanB on November 18, 2018, 11:56:02 am ---Fast-on connector, that spade terminal found on small lead acid batteries, on your car and pretty much every electric part used in airconditioners. A way to make assembly faster, but still capable of low resistance, decent resistance to corrosion and does not come loose easily.

--- End quote ---
How does a fast-on connect to braid on a shield?

--- End quote ---
If a total thickness of the shield wire is not that high, you could simply put a piece of heatshrink on it and then crimp the end as if it was a usual wire. If it is too thick for crimping, then solder a piece of wire to the shield and then crimp the wire.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod