Electronics > Projects, Designs, and Technical Stuff
This is becoming quite a challenge, but I managed it.
<< < (6/6)
Siwastaja:
Simple series resistors (say 47R) offer the benefit of providing some protection while being almost as cheap as no protection at all. 47R series + external schottkys to rails was used in Terasic's DE2 development board, for example, which we used extensively.

These small resistors protect from short circuits which IMO are the most probable way of killing IO on the "lab table". They also may protect from overcurrent damaging things through substrate diodes when you accidentally put a voltage on an IO pin of turned-off device - they also protect from small overvoltages such as 5V on 3.3V input, by limiting the IO cell diode current.

They won't properly protect from ESD, or severe overvoltages. But these resistors are almost free, and they prevent ringing of fast output signals by working as series termination, without slowing down the signal too much.
technix:

--- Quote from: Siwastaja on November 22, 2018, 07:33:09 am ---Simple series resistors (say 47R) offer the benefit of providing some protection while being almost as cheap as no protection at all. 47R series + external schottkys to rails was used in Terasic's DE2 development board, for example, which we used extensively.

These small resistors protect from short circuits which IMO are the most probable way of killing IO on the "lab table". They also may protect from overcurrent damaging things through substrate diodes when you accidentally put a voltage on an IO pin of turned-off device - they also protect from small overvoltages such as 5V on 3.3V input, by limiting the IO cell diode current.

They won't properly protect from ESD, or severe overvoltages. But these resistors are almost free, and they prevent ringing of fast output signals by working as series termination, without slowing down the signal too much.

--- End quote ---
I have 22R and ESD clamp diode packs, but those won’t fit here.

The boards arrived and preliminary testing suggests it works.
technix:
That board came back finally, and my first unit survived a tour in the city in my pocket.

I wonder what should the MCU provide to the FPGA? USB CDC is an easy one, ditto the 36MHz core clock. Now how should I make use of the SPI interface?
technix:

--- Quote from: james_s on November 18, 2018, 10:48:19 pm ---
--- Quote from: technix on November 18, 2018, 05:20:37 am ---I will make it available on my Tindie store for you, after the boards arrived and assed tests. Just do expect it being a bit expensive though, FPGA's aren't exactly cheap.

--- End quote ---

I was just looking at the state of things this morning and was a bit shocked at just how cheap they've become. The lowest end Cyclone 10 part for example is under $8 each in single quantities and it has quite respectable specs. I've been using the same older parts for quite some time now and had not bothered to check on the current offerings in a while.

--- End quote ---

Here it is: https://www.tindie.com/products/maxtch/sushibits-duplex-mini-2/
technix:

--- Quote from: tkamiya on November 18, 2018, 05:14:30 pm ---I'm budget challenged.....

--- End quote ---
Here you go: https://www.tindie.com/products/maxtch/sushibits-duplex-mini-2/
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod