Electronics > Projects, Designs, and Technical Stuff
Toner chip Ti046b1. Deep analize
(1/1)
PON:
Hi to everyone,

Based on this forum (https://www.eevblog.com/forum/projects/lexmark-toner-chip-ti046b1/?all#lastPost) i try to analize more deep this chip.
Why deep analize?
I have 3 resetter of Lexmark/Konica Minolta/Dell chip, and all of this resetter tell to some chip are BLOKED, or they can reset only some part (ex: 15%, 23%, 80%) from capacity.
Capacity of chip are write on this chip. I read almost 200 chips in diferit situation, to see if  this chip have some change in other place, not only in resetted block, but no diference.
I dump the chip from 00>00 to 19>FF, to check if are some diference, but no. Information from 00_00 to 09_FF are the same with, 10_00 to 19_ff.
I read on mono chip also 0x000 and 0x001. I try also to go on 0x002 and morestep, but no adress found.
Why i want deep analize is becouse, in Mono carytidge if i try to tell in reset the chip have 0 page, the printer tell me to replace the cartridge, becouse have 0 pages remain, and after printer try to block the chip. I read and dump chip before put in printer, and have 100% reseting ( also with resetter i have not only with arduino), and after i put in printer, i try to read and dump the chip again, to check what printer change. The resettwr tel me in some case, can reset maxim 15%, or are block. But...., i reset again with ardui o and rewrite with old information, and after the resetter tell me is new, but only with maxim 15% of capacity, or, are blocked. But NEW.
Can i find some good ideea to analize more deep this to check what change are there.
Many thanks for ideea
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod