Hello everyone,
I have a Hameg HM1004-3 and just bought and soldered this transistor curve tracer kit:https://www.ebay.com/itm/Transistor-Curve-Tracer-adapter-Oscilloscopes-Plus-Power-supply-UnAssembled-Kit/291531434190?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
On the Hameg manual, it says that Channel 2 is the X and Channel 1 is Y. When i connected the curve tracer that way all I get is a fuzzy picture (like there is no ground connection or something). If I connect it the other way around, making the necessary adjustments of the Volts/Division and triggering I get a clear picture of the curves but the curves are now going vertically.
The thing is, the scope seems to be triggering fine on both channels. Trying both channels out with signal sources produced the same image.
Ive read the manual over and over and I cant understand what is going on.
Any tips?
During the 2+ hours I spent trying to figure out what was going on, there was a moment (around 2 seconds) where it briefly worked, the curves where horizontal and I could see them clearly, but then it changed back to the fuzzy mess.
Pictures for reference