Electronics > Projects, Designs, and Technical Stuff

USB C routing: Will this work?

(1/2) > >>

hermitengineer:
I just switched from micro-USB to USB-C.  It's still 2.0 (actually even 1.0 compatible) and will only be using "full speed".  Should the routing shown below be within tolerance for track length?

semir-t:
Did this a lot of times and never had an issues. It is short distance for it to take an that much effect on the signals.

Just make sure that you have ground plane beneath the traces all the time.

tszaboo:
Full speed is 12 megabit. You can run one of the signals through a coat hanger and it would probably work.

hermitengineer:
As it turns out, you're probably right  :-DD

SiliconWizard:
Yes. ;D

But even HS would be fine with this routing. (Probably not with the coat hanger! :-DD )

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod