Electronics > Projects, Designs, and Technical Stuff
Using an AD584 for a 10.0 Volt 1.0 Amp DC Supply
<< < (3/3)
eevjohn:
I have today modified all my posts in this thread to remove words "Precision", "1%", "Calibrator", and a few attachments which are now superfluous.
It is still a useful circuit, and the original intent of the thread is still valid, ie, be cautious about instability.
Ysjoelfir:

--- Quote from: eevjohn on August 08, 2019, 08:28:40 pm ---I have today modified all my posts in this thread to remove words "Precision", "1%", "Calibrator", and a few attachments which are now superfluous.
It is still a useful circuit, and the original intent of the thread is still valid, ie, be cautious about instability.


--- End quote ---
That seems a bit childish to me.
The comments others here are giving may sound a bit harsh, but hey, we're in an engineering forum.
I would allow myself to assume, that most engineers aren't the outgoing, overly kind type of person but more the fact oriented, down to earch ones who like to present a meaning, bach that up with facts and that without giving too much attention to sounding especially nice.
This can sometimes lead to the impression that people are being rough and unfriendly, but most people here are just neutral while posting without any special attitude.

I personally like the project but I know about the shortcomings of this kind of build (experienced them myself, as I said, I build something quite simmilar some time ago), so I keep that in mind and like to know about the oppinions and tips others give me to improve my designs.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod