Electronics > Projects, Designs, and Technical Stuff
using the DRV8816 2x 1/2 bridge as high or low side switch
(1/1)
Simon:
i am looking at the following: http://www.ti.com/lit/ds/symlink/drv8816.pdf

If I pul the input to the side I want to operate and instead PWM the enable pin would this effectively allow me to select and control the highside or low side only?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod