Electronics > Projects, Designs, and Technical Stuff

using the DRV8816 2x 1/2 bridge as high or low side switch

(1/1)

Simon:
i am looking at the following: http://www.ti.com/lit/ds/symlink/drv8816.pdf

If I pul the input to the side I want to operate and instead PWM the enable pin would this effectively allow me to select and control the highside or low side only?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod