Electronics > Projects, Designs, and Technical Stuff
variable gain current amp
<< < (5/8) > >>
Simon:
I don't need too much accuracy.
Vovk_Z:

--- Quote from: Simon on May 15, 2020, 12:47:28 pm --- I have found MOSFETS for over 500A that are 300µOhm. I will use 2 in parallel.

--- End quote ---
- it seems like a bit no-good design - use two 500 A mosfets to measure 0.05-5 A. What resolution do you need? Look into books like "Opamp application" etc, you definitely find strait way to measure what you need (you have to calculate an error budget).
Jay_Diddy_B:
Hi,
How are you measuring the output of the current amplifier?

How many bits do you have?

Can it work close to ground?

Jay_Diddy_B
Vovk_Z:

--- Quote from: Jay_Diddy_B on May 15, 2020, 01:24:31 pm ---Take a look at this:

--- End quote ---
:-+
Simon:

--- Quote from: Jay_Diddy_B on May 15, 2020, 05:13:16 pm ---Hi,
How are you measuring the output of the current amplifier?

How many bits do you have?

Can it work close to ground?

Jay_Diddy_B


--- End quote ---

it will go to a panel meter. I can get meters that measure 200mV, 2V, 20V. I don't need it to be highly accurate. It's more about repeatability.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod