Electronics > Projects, Designs, and Technical Stuff

Very tall SMD LEDs?

(1/2) > >>

jayeye:
I need to mount indicator LEDs 30mm above the PCB. I'm making fewer than ten pieces of this, so having light pipes manufactured is not an option. I *could* solder some wire to ordinary T-1 (3mm) LED to lengthen the pins, and even twist it so they become surface-mount, but that's way too ugly, and in any case the leads are not stiff enough to keep the LEDs properly positioned. I looked through LED accessories on Digikey, but I can't find anything suitable. Suggestions?

/ji

djacobow:
I wonder if you could "manufacture" a few light pipes using some plexiglass and some careful sawing.

sokoloff:
For fewer than 10, I'd probably just use a tiny daughter board with pin headers and Dupont F-F jumpers to join the main board.

fossil:

--- Quote from: jayeye on February 10, 2019, 01:16:48 am ---I need to mount indicator LEDs 30mm above the PCB. I'm making fewer than ten pieces of this, so having light pipes manufactured is not an option. I *could* solder some wire to ordinary T-1 (3mm) LED to lengthen the pins, and even twist it so they become surface-mount, but that's way too ugly, and in any case the leads are not stiff enough to keep the LEDs properly positioned. I looked through LED accessories on Digikey, but I can't find anything suitable. Suggestions?

/ji

--- End quote ---

Checkout out Light Pipes at https://lcsc.com/products/LED-Light-Pipes_977.html

Kasper:
Search DK for 'light pipe'.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod