Electronics > Projects, Designs, and Technical Stuff

Vibration resistant, waterproof enclosure

(1/2) > >>

EEBlackSheep:
I am putting together an ECU for a dirt bike.  Lots of vibration, lots of  water, and from time to time, submersion.  Sadly I am not an engineer (comp sci - dont shoot me!).  I am looking for engineering guidelines for circuit assembly and enclosure design for vibration resistance and waterproofness (IP68?).

thanks for any help
DC

e100:
Visit a scrap yard and find a wreck from which you can extract the ECU enclosure, wiring harness and connectors.
As for components, just don't buy from Ebay or Aliexpress as they will either be fake or recycled from old gear.

EEBlackSheep:
Thanks for the tip, but I am looking for electronics engineering guidelines for IP68/Vibration resistance rather than salvaging an existing ECU enclosures.  Existing ECU enclosures are too big for a dirt bike.  I also want to understand the best practices for build IP68/vibration resistant designs.

Gyro:
You'll probably do as well as anything with this style of sealed Aluminium diecast enclosure (check the Technical datasheet on the page for more detail)...
https://uk.farnell.com/rose/01-08-18-06/enclosure-aluminium-80x175x57mm/dp/4744081?st=diecast%20enclosure

They have an O-ring and lip seal, with all mounting and lid fixing screws outside the seal. They're rated IP66 but with additional sealant you could probably make it up to IP68. Some thread lock on the fixing screws would get you the vibration resistance.

Kasper:
Digikey and probably other electronic component vendors have lots of enclosures. And you can filter for enclosures with IP-68.

https://www.digikey.ca/products/en/boxes-enclosures-racks/boxes/594?k=&pkeyword=&sv=0&pv707=360152&sf=1&FV=-8%7C594&quantity=&ColumnSort=0&page=1&stock=1&pageSize=25

Conformal coating or potting the electronics can help too.  I once bought a 'new' brake light for my dual sport from a reputable store. It died first ride so I took it apart and it looked corroded and had multiple broken solder joints. I think it was an old repaired unit.  Took pictures and got refund then fixed some solder joints and conformal coated the PCB and it lasted atleast until the bike was stolen acouple years later.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod