Electronics > Projects, Designs, and Technical Stuff

Voltage selector wiring using faston - Am I missing something?

(1/6) > >>

pope:
Please consider the following image/ diagram of a power module with incorporated fuse and voltage selector.  In this case an external power DPST is needed.

I believe that the wiring is correct. Is it?

If the IEC inlet's connectors are "solder lug" I can easily combine two wires into one lug as shown on the image (1&4), but how on earth do I do this if the module has "quick connect/ disconnect"? I really don't like the idea of crimping two wires onto one faston. What am I missing here?

themadhippy:

--- Quote ---I really don't like the idea of crimping two wires onto one faston. What am I missing here?
--- End quote ---
piggy back fastons

Benta:

--- Quote from: themadhippy on May 20, 2024, 05:15:56 pm ---
--- Quote ---I really don't like the idea of crimping two wires onto one faston. What am I missing here?
--- End quote ---
piggy back fastons

--- End quote ---

Yep. Work beautifully.

pope:
OK I see, thanks. I wasn't aware of these.

Do you know if sleeves for piggy back fastons exist? Something like this on the pic but for the piggy back ones. I can't find anything...


Benta:
Just use the normal ones.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod