Electronics > Projects, Designs, and Technical Stuff

Weird HP Power Supply Circuit

(1/2) > >>

Gregory:
Hello!

I`m trying to repair a HP 35660A power supply that failed.

As I was not able to find the schematic, I`m doing a bit o reverse enginnering to see how the power supply works.

On this power supply I came across a power driver design that I never saw before, this is the LTSpice print that I simulated.
(I used a resistor in place of the main transformer only for simulation purposes)


Q1 is the main switching transistor.
The weird thing is that M1 is a FET that is in series with Q1! In between them it has a small transformer that appears to be a boostrap transformer to inject base current on Q1.

The zeners are a small voltage supply that bias the base of Q1 with a small current to start the conduction.

So, Q1 is controlled by its emitter by M1 and when it starts to conduct current the bootstrap transformer reforces the base current. Very weird.

Why do you think they used this design ?
I can't see any advantges of this counblesome design.

Thanks!

Cliff Matthews:
Check the description text below EEVblog video #523 - I think you'll find the resources you need.
* Spoke too soon :)  I re-checked the svc man PDF and you can find it here.



Gregory:
Thank you for your repply but the document don`t contain details abou the power supply!

Andy Watson:
Weird! I'm going to guess that it is a slight variation on a cascode circuit, i.e. it is an attempt to reduce the miller-effect around M1.

Another possibility is that M1 is only good for 100V whereas Q1 is good for 1000V - perhaps there was an ecconimic reason for using a Mosfet and the IRF530 was the best they could obtain at the time.

NiHaoMike:
That's called an "ESBT", Emitter Switched Bipolar Transistor.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod