| Electronics > Projects, Designs, and Technical Stuff |
| What glue/adhesive use for Sendust/Kool Mu E core assembly ? |
| (1/2) > >> |
| Miyuki:
Hi folks, do you have any recommended glue for bonding E cores made from Sendust together and also for mounting core to PCB ? |
| coppercone2:
thin superglue or manufacturers recommendation |
| Miyuki:
So I have reply from manufacturer, if you need to glue this type of material: This powder type material cannot be glued by thin superglue, but can be used thick rubber filled superglue like Loctite 410, Cyberbond 2241 Or use two component epoxy |
| jbb:
I suggest you check the temperature rating on the glues too - superglue may come unstuck... |
| gka_0509:
"Resinlab EP950G is a one part epoxy adhesive that is recommended for use on Powder Core materials. This adhesive has good strength at room temperature and retains strength at high temperature." https://www.mag-inc.com/Products/Powder-Cores/Learn-More-about-Powder-Cores |
| Navigation |
| Message Index |
| Next page |