Electronics > Projects, Designs, and Technical Stuff

What glue/adhesive use for Sendust/Kool Mu E core assembly ?

(1/2) > >>

Miyuki:
Hi folks,

do you have any recommended glue for bonding E cores made from Sendust together and also for mounting core to PCB ?

coppercone2:
thin superglue or manufacturers recommendation

Miyuki:
So I have reply from manufacturer, if you need to glue this type of material:

This powder type material cannot be glued by thin superglue, but can be used thick rubber filled superglue like Loctite 410, Cyberbond 2241
Or use two component epoxy

jbb:
I suggest you check the temperature rating on the glues too - superglue may come unstuck...

gka_0509:
"Resinlab EP950G is a one part epoxy adhesive that is recommended for use on Powder Core materials. This adhesive has good strength at room temperature and retains strength at high temperature."
https://www.mag-inc.com/Products/Powder-Cores/Learn-More-about-Powder-Cores

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod