Electronics > Projects, Designs, and Technical Stuff
What is this circuit doing?
(1/1)
elimenohpee:
I developing an application where I need to current share a couple of external, stand-alone DC switch mode power supplies.  I'm planning to use TI UC2907 as a load share controller.  There aren't any application notes specifically on this chip, but there is a note on UC3907 with an approach that I want to use.  It looks like it ties into the sense feedback lines to drive/share the current between the supplies. 

In the application note it shows a rough schematic of the approach (see the attached image), but I'm a little confused what the highlighted portion is doing.  It looks like it's clamping the emitter of the transistor at the chip's reference voltage but I don't really understand why.  Does anyone have any idea what this portion of the circuit is doing?
Mr Evil:
From looking at the block diagram in the datasheet, pin 8 is a 1.75V reference voltage, so it will pull up the emitter of the transistor by a few hundred millivolts, preventing it from pulling down on the power supply's sense line until the output from the adjust amplifier rises above a threshold. Without spending too much time trying to work it out, it seems that this is because the output from the adjust amplifier is >0V under quiescent conditions, so R3 prevents it from constantly trying to adjust the power supply's output even when there is no current output from it.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod