Electronics > Projects, Designs, and Technical Stuff
What is this plastic dingus called?
Alex Eisenhut:
The clip that holds the tiny circular helitrim pots on the PCB?
These pots are about 6mm in diameter. Attached is a picture of two of these little guys on a very dusty 1S2.
I've searched for holder, clip, and pcb mount. Nothing.
I'm also asking on Tekscopes but it's so much easier to attach pictures here... 8)
andy3055:
I believe it is listed in the service manual as "HOLDER, variable resistor." Page: 9-10. Several other places has the same ref.
mikerj:
Probably a custom part. You might find something suitable in the automotive sector, this kind of thing is often used for clipping pipes etc. to metal panels.
MLXXXp:
Could you get away with a small cable tie holder and tie?
https://www.digikey.ca/en/products/detail/panduit-corp/TM1A-M/4569096
DaJMasta:
Looks like it was probably designed for the pots in question, and I don't know of availability now. A prime candidate for 3d printing, but as mentioned a replacement with similar functionality but different looks probably isn't hard to come by.
Navigation
[0] Message Index
[#] Next page
Go to full version