| Electronics > Projects, Designs, and Technical Stuff |
| Which scope? |
| << < (3/3) |
| tautech:
--- Quote from: Rat_Patrol on February 20, 2020, 04:37:29 am ---I still need a scope, the SPI decoding and cam signal capture were the only projects I had waiting in line for it. --- End quote --- You can do basic SPI decoding with the 2ch SDS1202X-E just using the clock and data line and instead of clock sense (CS) use CLK Timeout. This screenshot is from a much higher spec SDS5054X and although the UI is different the same settings will apply: |
| Prehistoricman:
The 1054Z's interface is not just sluggish. The horiz and vertical movement is particularly bad because the acceleration feature usually kicks in at the worst moment. You're nudging your signal over to get it in the right place and all of a sudden it teleports off screen. FW doesn't get updates any more AFAIK but it still has bugs. I've experienced memory corruption on the trace in normal/stop mode. |
| TK:
--- Quote from: tautech on February 20, 2020, 09:04:22 am --- --- Quote from: Rat_Patrol on February 20, 2020, 04:37:29 am ---I still need a scope, the SPI decoding and cam signal capture were the only projects I had waiting in line for it. --- End quote --- You can do basic SPI decoding with the 2ch SDS1202X-E just using the clock and data line and instead of clock sense (CS) use CLK Timeout. This screenshot is from a much higher spec SDS5054X and although the UI is different the same settings will apply: --- End quote --- Is the screen showing a single shot? Why MOSI is showing transitions after SIGLENT_ ? All screenshot posts of the SDS5000X and SDS2000X Plus show the same behavior |
| Navigation |
| Message Index |
| Previous page |