Electronics > Projects, Designs, and Technical Stuff

Who makes this connector?

<< < (3/3)

tooki:
You could probably look up specs for individual 2.8mm Faston spade connectors to determine the rough electrical characteristics.

Monkeh:

--- Quote from: tooki on July 26, 2020, 05:36:22 pm ---You could probably look up specs for individual 2.8mm Faston spade connectors to determine the rough electrical characteristics.

--- End quote ---

And, doing that (nice work finding the original parts btw), TE rate 110 Fastons at 5A continuous, 10A intermittent with 16AWG wire. The intermittent is 75% duty cycle and allows for up to 85C rise. So in nylon/ABS housings like this I would suggest 4A continuous is probably reasonable. Assuming they're a decent fit, which is questionable with knockoffs.

calzap:
Thanks.  I don't use them at more than 0.5 A, but good to know the limits.  Actually the solenoids and relay coils are less than 300 mA sealed, but inrush can be 0.4 A.  Voltage rating depends on geometry and insulation characteristics of the shell.  I use them at 24 VAC and would never go over 50 V, so feel safe with that.

Mike

tooki:
Yeah, I think you’re very, very comfortably within their capabilities, with lots of room to spare.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod