Electronics > Projects, Designs, and Technical Stuff
Wirewrapping on the cheap - pin headers.
<< < (3/3)
stockvu:
Let me chime in for those who read this topic later.

I've used traditional wire-wrap and had the same problems with cost and availability as the OP. I like what the OP shows in his pictures. That's a slick way to build resilient circuits!  :)

In my situation, I tried wire-wrapping thru-hole headers inserted into solderless breadboards. For me, this was a good way to get somewhere for reasonable time and cost. Then I discovered you could make plug-able cables using headers and wire-wrap too!    8)

This meant not using jumpers (aka push wires) which eliminated intermittents and rats nest issues!

I wrote a website about this wiring technique (search for permanent solderless if you're interested).



However, I found there are strict rules one must abide by to sidestep problems using the above tactic.

FWIW
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod