Electronics > Projects, Designs, and Technical Stuff

Wirewrapping on the cheap - pin headers.

<< < (3/3)

stockvu:
Let me chime in for those who read this topic later.

I've used traditional wire-wrap and had the same problems with cost and availability as the OP. I like what the OP shows in his pictures. That's a slick way to build resilient circuits!  :)

In my situation, I tried wire-wrapping thru-hole headers inserted into solderless breadboards. For me, this was a good way to get somewhere for reasonable time and cost. Then I discovered you could make plug-able cables using headers and wire-wrap too!    8)

This meant not using jumpers (aka push wires) which eliminated intermittents and rats nest issues!

I wrote a website about this wiring technique (search for permanent solderless if you're interested).



However, I found there are strict rules one must abide by to sidestep problems using the above tactic.

FWIW

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod