Electronics > Projects, Designs, and Technical Stuff
Yet another resistance decade box
<< < (73/87) > >>
bitseeker:
60 end caps? ???
Back2Volts:

--- Quote from: LeonV on September 02, 2016, 08:58:39 am ---Finally got my decade switches today.. And i mentioned to the seller he should sell the end caps.
But instead he gave me 60 end caps.

The boards fit like a glove in the switches i bought too. Looking forward to spending time soldering them!

--- End quote ---

Who is that seller ?    I ordered from an eBay seller a black set and it shipped with caps.   Then I ordered from the same seller two more sets, white and grey and they shipped without caps.  I think this guys have no clue about the use of what they are selling.
JacquesBBB:
@Fortran :
I received the boards send with excellent packaging and labels.

I  have done the first set.  Due to the quality of the boards, it was a very pleasant soldering exercise.
I am now waiting for the switches that I ordered here
http://www.ebay.fr/itm/301726653090?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

By the same time I learned than Aland  existed, which I had never heard of before. So thanks for everything.
bitseeker:

--- Quote from: Back2Volts on September 03, 2016, 01:49:13 am ---I ordered from an eBay seller a black set and it shipped with caps.   Then I ordered from the same seller two more sets, white and grey and they shipped without caps.  I think this guys have no clue about the use of what they are selling.

--- End quote ---

That's not uncommon with sellers on eBay, AliExpress, etc. when it comes to tech products. Don't expect much. They're just selling whatever they can. Look at what else they have for sale. Many sell underwear, cosmetics and dresses in the same online store as switches, resistors and microcontrollers.
Back2Volts:
I am almost done with the mechanical side of my first resistor set.   I have used the smallest plastic box I could find to fit the parts in.   It is 25 x 35 x 60 mm.   Using low profile 4mm jacks (10mm back end) at 19mm separation.  Micro jacks for breadboard use.  The micro jacks are not press fit yet into the plastic.   The switch set came without caps.  I cut the square window by drilling the corners and using a hand micro saw and some final filing.   

I have not soldered anything yet.  That will be in a few days after I receive and destroy a cheap learning kit.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod