Electronics > Projects, Designs, and Technical Stuff
Yet another resistance decade box
<< < (75/87) > >>
Back2Volts:

--- Quote from: nikifena on August 31, 2016, 05:08:34 pm ---
Also I finished my 3D project for the enclosure. I will make it from 1mm sheet metal.

Cheers, Niki

--- End quote ---

That model looks very nice.   What kind of tooling you have to build that box from scratch ?   Seems like a lot of work.   Do you have access to a CNC ?
bitseeker:

--- Quote from: Back2Volts on September 04, 2016, 01:59:44 pm ---There is no doubt that shrouded sockets give additional flexibility, but I wonder how many people with an extra pair of shrouded test leads would not have shorter plain banana leads with mini-clips or the like which probably would be more manageable in a testing environment where you would use these resistor sets.   
--- End quote ---

Retractable shrouds for the win! :-+
ebclr:
I'm using in mine a XT60 connector is really better that then average banana plug, very low resistance and good mechanical fit



mrjoda:
i just finished my kit. Put new pcb's into switch was quite hard, but it is very solid  :-+

i did some measurements on my 34401A, cable Parrot Invents PCM W3, unfortunately, only 2 wire because i have only one pair of cables. So...

now will came the hard part - find the right BOX ! I have some candidates

for example http://www.ebay.com/itm/380867568516?
anfang:
How did you remove the original PCB from the housing?

I tried pulling them but they seem stuck. Someone in the thread said the PCBs are kept in places with melted plastic. |O I do not see any melted part in the one I have...
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod