Electronics > Projects, Designs, and Technical Stuff
Yet another resistance decade box
Back2Volts:
--- Quote from: nikifena on August 31, 2016, 05:08:34 pm ---
Also I finished my 3D project for the enclosure. I will make it from 1mm sheet metal.
Cheers, Niki
--- End quote ---
That model looks very nice. What kind of tooling you have to build that box from scratch ? Seems like a lot of work. Do you have access to a CNC ?
bitseeker:
--- Quote from: Back2Volts on September 04, 2016, 01:59:44 pm ---There is no doubt that shrouded sockets give additional flexibility, but I wonder how many people with an extra pair of shrouded test leads would not have shorter plain banana leads with mini-clips or the like which probably would be more manageable in a testing environment where you would use these resistor sets.
--- End quote ---
Retractable shrouds for the win! :-+
ebclr:
I'm using in mine a XT60 connector is really better that then average banana plug, very low resistance and good mechanical fit
mrjoda:
i just finished my kit. Put new pcb's into switch was quite hard, but it is very solid :-+
i did some measurements on my 34401A, cable Parrot Invents PCM W3, unfortunately, only 2 wire because i have only one pair of cables. So...
now will came the hard part - find the right BOX ! I have some candidates
for example http://www.ebay.com/itm/380867568516?
anfang:
How did you remove the original PCB from the housing?
I tried pulling them but they seem stuck. Someone in the thread said the PCBs are kept in places with melted plastic. |O I do not see any melted part in the one I have...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version