Electronics > Projects, Designs, and Technical Stuff
Yet another resistance decade box
<< < (77/87) > >>
ivaylo:

--- Quote from: nikifena on September 21, 2016, 07:03:25 am ---Finally I finished my decade box.
The enclosure is made from 1mm sheet metal.

--- End quote ---
Goog job, Niki! You didn't say how. you produced the metal box from the nice drawing you posted before...
nikifena:
Thanks ivaylo. I'm making electronic devices and have good experiance with sheet metal work. I made all of my enclosures 3D and then I send the files for production in my town. The process is pretty simple - laser cut, bending on a press brake and finaly powder coating. Because this is only one enclosure I prefer to place labes made with transparency foil printed with laser printer, but silkscreen is much better for mass production and gives much higher quality looks :)

If you guys like this enclosure, I can make similar like this one in a small batch. The price will be about 12-15 Euro imho.
Back2Volts:

--- Quote from: nikifena on September 21, 2016, 07:03:25 am ---Finally I finished my decade box.
The enclosure is made from 1mm sheet metal.

--- End quote ---

It looks great!   Did you actually build the box yourself ?     
nikifena:
^ I made all necessary sketches for fabrication, but I use few local companies to produce the enclosures.
ebclr:
I used a hot hair, on the plastic pin, instead of cutting, On this way I can remelt after change the board
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod