Electronics > Projects, Designs, and Technical Stuff

Yet another resistance decade box

<< < (77/87) > >>

ivaylo:

--- Quote from: nikifena on September 21, 2016, 07:03:25 am ---Finally I finished my decade box.
The enclosure is made from 1mm sheet metal.

--- End quote ---
Goog job, Niki! You didn't say how. you produced the metal box from the nice drawing you posted before...

nikifena:
Thanks ivaylo. I'm making electronic devices and have good experiance with sheet metal work. I made all of my enclosures 3D and then I send the files for production in my town. The process is pretty simple - laser cut, bending on a press brake and finaly powder coating. Because this is only one enclosure I prefer to place labes made with transparency foil printed with laser printer, but silkscreen is much better for mass production and gives much higher quality looks :)

If you guys like this enclosure, I can make similar like this one in a small batch. The price will be about 12-15 Euro imho.

Back2Volts:

--- Quote from: nikifena on September 21, 2016, 07:03:25 am ---Finally I finished my decade box.
The enclosure is made from 1mm sheet metal.

--- End quote ---

It looks great!   Did you actually build the box yourself ?     

nikifena:
^ I made all necessary sketches for fabrication, but I use few local companies to produce the enclosures.

ebclr:
I used a hot hair, on the plastic pin, instead of cutting, On this way I can remelt after change the board

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod